The responsibilities and authorities for this position include, but are certainly not limited to: Quality Planning - The responsibilities for planning include but are not limited to the following: Control Plan (PQCT), FMEA and Process Flow development as needed Part validation and test plans, including PPAP protocol, as position requires Part requirement clarification (appearance, fit to vehicle, performance, etc.) Incorporation of lessons learned Assist in Operator training plans Working with customers and Program Management on the above Implementation (Do) of the planned quality activities including but not limited to: Development of documentation to support the Control Plan including check sheets, test procedures, data record sheets etc. Completion or outsourcing of testing to support program timelines Submissions for appearance, IMDS, DVP&R, NMRs, AAR, etc. as needed Development of launch instructions and inspector training Development of operator work instructions including packaging instructions as required Development of master and boundary samples as needed Coordination of training to support the plan Communication with Program Management and customer on the above Checking on the output from the planned process including but not limited to: Completion and analysis of test requirements, and may include ability to coordinate systems and alignment techniques Control Plan and process audits at all pre-production run/builds Verification of operator training and compliance to work instructions at all pre-production runs/builds Run at Rate participation and evaluation PPAP submissions with ability to determine actions from data reports Reviewing and approving all related supplier part submissions/NMRs (New Model Reviews), AAR (Appearance Approval Reports) Acting on discrepancies found during checks including: Communication of performance or functional failures to production and Program Management as needed Updating documentation related to checks or process/part changes Complete data administration, as necessary Responses to Paint Supplier and or customer concerns Coordination and verification (under the direction of Program Management) on all engineering changes at their specific location. Other responsibilities: Promote an atmosphere of team work at all times Ensure that a clean and safe work environment is always maintained Assist in any way to any employee, necessary to promote a successful operation emphasizing customer satisfaction Knowledge and ability to operate Romer 3D Lazer Sanner, interpret data & actions from reports (WP1), as needed Knowledge and experience with GD&T, as needed Continuous improvement activity involvement at the discretion of the Quality Manager Involvement in problem solving related to customer issues and concerns Train Quality Auditors on proper inspection techniques, record completion and other training areas Assist in training of production operators along with the Quality Supervisor Ensure personal and associate awareness and understanding of ISO 14001 and ISO/TS 16949 (includes ISO 9001) Standards, and company policies and procedures During management system audit events provide evidence in support of conformance with applicable standards and procedures, and participate in corrective action activities as necessary Complete any other duties as assigned MINIMUM EDUCATION/OR DESIGNATION REQUIREMENTS: Must possess a secondary school diploma or equivalent, with preference given to those who have completed some or all of a College level program including CQE. MINIMUM WORK EXPERIENCE REQUIREMENTS: • Must have the ability to be trained for the above mentioned responsibilities and authorities • Acceptable performance record and attendance record required • 5+ years working in an automotive Tier supplier. Preferably with paint experience INDQSS
