Position Overview: The Front End Maintainers work 12-hour shifts on for four days and off for four days. The Front End Maintainers initiate the can making process and responsible for the set up, operation and maintenance of the cupping press, body makers, trimmers, and conveying systems. Duties And Responsibilities: Inspect, upend and load coils onto the unwinder and feed coils through lubricator and into press. Set-up, maintenance and operation of the upender, unwinder, lubricator, and cupping press. Set-up, maintenance and operation of the body makers, trimmers, and conveying systems. Inspect and monitor, then enter into computer the following can specifications: - flange wall thickness - mid-wall thickness - dome depth - trim can height Perform visual checks and cup weights to insure that process is in compliance and take appropriate measures. Assist in other areas as needed to maintain smooth can flow through the plant. Complete required paperwork and documentation such as coil log, check sheets, etc. Maintain cleanliness of all work areas and machines and practice proper safety procedures. Performs other job-related duties as required or assigned Working knowledge of pneumatics and hydraulics Basic knowledge of how electrical components work Ability to use precision measurement devices (i.e. calipers, micrometers and dial indicators) --s-p-m1-- By applying, you consent to your information being transmitted by Monster to the Employer, as data controller, through the Employer's data processor SonicJobs. See Crown Cork and Seal Terms & Conditions at https://www.crowncork.com/legal-notice and Privacy Policy at https://www.crowncork.com/privacy-policy and SonicJobs Privacy Policy at https://www.sonicjobs.com/us/privacy-policy and Terms of Use at https://www.sonicjobs.com/us/terms-conditions